The Standard Series consists of a family of cable extension linear position and linear velocity transducers in a NEMA 1 (IP-40) housing. The transducer mechanism is housed inside of an aluminum cover and attached to an anodized aluminum baseplate with four mounting holes. The measurement range determines which of three housing sizes is to be used. All of the possible UniMeasure analog and digital position outputs are offered in the Standard Series. The wire rope exit is perpendicular to the baseplate as shown in the photo but optional side and bottom wire rope exit locations are available. Other options include nylon jacketed wire rope, dust wiper, terminal strip, non-standard potentiometer, and alternate connector location.

 
PA Series - Analog Position
Ratiometric output voltage from a precision potentiometer configured in a voltage divider circuit. Requires regulated input voltage up to 30 V maximum.


Drawing files, DXF Format:
 
P420 Series - Analog Position
Loop powered 4 to 20 mA current transmitter with adjustable zero and span controls. Input voltage is 9V to 35V depending upon total loop impedance.


Drawing files, DXF Format:
 
EP Series - Analog Position
Digital, TTL level, two channel square wave output signal. 5 VDC input voltage. Optional configurations include 8 to 28 VDC, current sinking, push-pull & line driver capability


Drawing files, DXF Format:
 
V Series - Velocity
Linear velocity transducer that incorporates a self-generating tachometer with voltage output that eliminates the need for any external power supply.


Drawing files, DXF Format:
 
PB Series - Analog Position
Precision potentiometer in bridge circuit with integral zero and span controls which facilitate interfacing to a bridge amplifier. Requires regulated input voltage up to 30 V maximum.


Drawing files, DXF Format:
 
P510 Series - Analog Position
P510 Provides a 0 to 10 VDC or 0 to 5 VDC voltage output and -10 VDC to +10 VDC or -5 VDC to +5 VDC voltage output. Includes adjustable zero and span controls. Requires input voltage of 4.9 to 30 VDC (unregulated acceptable).


Drawing files, DXF Format:
 
VP Series - Velocity/Position
VP Series combines a self-generating tachometer and a percision potentiometer to give both velocity and analog position.

Standard VP Installation Guides:

Drawing files, DXF Format:
 

 

Home | Selection Guide | Products | Applications | How They Work | Trade Shows | Representatives | E-mail